3 dimensions, 4 connection to the device – EVCO EVF818P9 User Manual
Page 70
Advertising
EVCO S.p.A.
EVF818 | Installer manual ver. 1.0 | Code 144F818E104
page 70 of 76
14.5.3
Dimensions
The following drawing illustrates the PM 100A X9S001 dimensions; these are expressed in mm (in).
Part
Minimum
Typical
Maximum
A
92,0 (3,622)
92,0 (3,622)
92,8 (3,653)
B
92,0 (3,622)
92,0 (3,622)
92,8 (3,653)
14.5.4
Connection to the device
Operate as follows:
1.
Make sure that parameter L0 is set at 1.
2.
Cut the device power supply off.
3.
Disconnect the PM 100A X9S001 power supply.
4.
Connect the device RD-485 serial port to the PM 100A X9S001 RS-485 type serial port.
5.
Connect the device power supply.
6.
Connect the PM 100A X9S001 power supply.
For further information, consult the documentation relative to PM 100A X9S001.
Advertising