Fleet Engineers INS-20013 - Manual

1. Assemble mud flap
bracket to Adjust-A-Mount
with 1/2” flat washers and
1/2” nuts (nuts supplied
with mud flap bracket).
Loosely tighten.
Each Adjust-A-Mount Kit Includes*
A) Adjust-A-Mount Brackets (2)
B) 1/2” Flat Washers (4)
C) 1/2-13x1-3/4 Set Screws (2)
D) 3/4-10x3-1/4” Bolts (2)
E) 3/4-10 Nuts (2)
F) 3/4” Lock Washer (2)
3. Rotate Adjust-A-Mount to the desired position for the height
of the mud flap bracket then tighten bolt and torque to 425
ft. lbs. minimum.
BACK VIEW FRONT VIEW
Installation Instructions
pAtENt
#6,435,462,B2
R
R
R
2. Select a hole in the frame for mounting. position Adjust-
A-Mount to hole, insert bolt and attach with a 3/4 x 3-1/4”
bolt lock washer and nut. Loosely tighten.
4. thread jamming set screw into appropriate hole. Adjust it
to contact truck frame and tighten to 13-15 ft. lbs. (recom-
mended) or until a slight deflection of the adjust-A-Mount is
seen.
5. If necessary, adjust the mud flap bracket until the mud flap
hangs vertically. tighten nuts and torque to 57 ft. lbs.
OR
Tighten Nuts
Behind Mount
R
R
R
1/2” Nuts (4) -not included
B) 1/2” Flat Washers (4)
E) 3/4-10 Nuts (2)
D) 3/4-10x3-1/4”
Bolts (2)
F) 3/4” Lock Washer (2)
A) Adjust-A-Mount
Bracket (2)
*mud flap brackets not included
C) 1/2-13x1-3/4
Set Screws (2)
NOtE: these instructions for installation are intended to be
a general guide to help the installer. Because of the large
number of possible mounting configurations, the in-
staller is responsible for the installation design.
Any modifications to the product are at the
discretion, responsibility and risk of
the installer.
Installation Sheet
#INS-20013
Installa
tion Sheet #INS-20013
7/00•1500 • Rev
.B- 10/06