Fleet Engineers INS-04031 - Manual

Installation Sheet #INS-04031 • 1/04 • Rev B 10/04 • Rev. C 12/06
FB-27 Mounting Procedure
& End Cap Installation
Installation Sheet #INS-04031
NOTE: These installation instructions are intended to be a general
guide to help the installer. Because of the large number of pos-
sible mounting configurations, the installer is responsible for the
ultimate installation design. Any modifications to the product are
at the discretion, responsibility and risk of the installer.
1. Make sure the area of the frame where the bracket is to be
mounted is clean and free from obstructions and protru-
sions. The frame seat of the bracket must come in full
contact with the frame.
2. Locate the bracket in the desired position. Make sure the
frame seat does not extend past the bottom edge of
the frame. Mark the location of the bolts.
FRAME SEAT
1.12"
FRAME
3. Drill 17/32” clearance holes for the bolts.
NOTE: Be sure to follow truck manufacturers recommended
procedures for drilling any required holes in the frame.
4. Install bracket and torque nuts to a maximum of 57 ft.
lbs.
NOTE:
Mounting the FB-27 with the
frame seat extending past the
bottom of the frame will void the
warranty.