Flyzone HCAA1981 - Manual (Page 5)

❏
2. Attach two additional rubberbands, crossing them
over the top of the wing.
❏
1. The transmitter that controls your airplane requires
power, in the form of eight “AA” batteries. To install the
batteries loosen the screw on the bottom of the
transmitter and remove the battery hatch.
❏
2. Pull the battery
holder out of the
transmitter case and
install eight new “AA”
batteries in the holder
following the diagram
on the holder.
❏
3. Insert the battery holder in the transmitter case so
that the two contacts on the battery holder align with
the contacts in the transmitter case. Reinstall the battery
hatch on the transmitter case and tighten the screw.
❏
4. Switch on the transmitter and check the LED on
the front of the transmitter. If the green light is on, it is
safe to fly. If the red light is on or flashing, you need to
install fresh batteries.
❏
5. On the front of
the transmitter are
three switches. The
two switches on the
left are for reversing
the direction of the
servos. The mixing
switch on the right
turns the V-tail mixing
on or off. Set ch.1
switch to NOR, ch.2 to
REV and mix to ON.
Caution:
•Do not use rechargeable (NiCd) batteries.
•Do not mix old and new batteries.
•Do not mix alkaline, standard (carbon-zinc) or
rechargeable (NiCd) batteries.
PREPARE THE TRANSMITTER
5