Installation and removal of the lipo battery, Power the ttx402 and center the trims – Flyzone FLZA2020 User Manual

Page 6

Advertising
background image

Keep hands clear of propeller during battery installation and removal.

Use two fingers to secure
connector during battery
installation and removal.

Connect the LiPo to the battery.

Press battery into
place to secure.

6

INSTALLATION AND REMOVAL OF THE LIPO BATTERY

Disconnect and remove the battery after use by holding the battery lead with two fingers and removing the battery
from the lead with the other hand. Do not yank or jerk the battery from the aircraft. This could pull the TR421 Rx
board loose from the fuselage.

Illuminated red light
indicates the TTX402
is powered and transmitting.

Center the rudder and
elevator trims.

Leave the left stick

(throttle control) in

the minimum position

during setup.

Power switch “ON”.

TRIM ADJUSTMENT

Full extent............. Centered ........... Full extent

Constant «beep» .....Single «beep» ..... Constant «beep»

POWER THE TTX402 AND CENTER THE TRIMS

Advertising