Flyzone FLZA2020 - Manual (Page 8)

8
Moving the pushrod inward
increases the control throw
Control Surface
Moving the pushrod outward
decreases the control throw
Use caution when removing
and reinstalling the pushrod
in the control horn to avoid
accidentally disconnecting
the linkage from the Rx board.
ADJUSTMENT OF LINKAGES: ELEVATOR AND RUDDER
To increase or decrease the control throws, follow these steps. Be sure to unpower the model before attempting to
mechanically adjust the linkages.
Keep hands and onlookers clear of the propeller during arming and operation.
Throttle control stick is in the low
or minimum position. Return the throttle control stick to
the minimum position. «Beep Beep»
The motor is now armed. Raise the throttle control stick
to the maximum or high position.
«Beep»
ARM THE PROPELLER
Press and hold one of the corresponding
control surface trim buttons and cycle the
power to reverse any control surface.
REVERSE THE CONTROL THROWS
Unplug the battery from the plane before reversing
the control throws. Only perform this procedure if the
control surfaces move in the wrong direction.