Futaba GY601 - Manual (Page 19)

19
D
ATA
S
ETTING
Flight mode
Initial value : F3C
Switches the flight mode. Settings are F3C or 3D.
The F3C mode emphasizes tail suppression and stop. The 3D mode
slightly sacrifices tail suppression and stop, but lets you control
pirouette speed completely proportional with the rudder stick
operation amount and is suitable for 3D flight.
<3D mode steering angle setting>
During 3D mode setting, the transmitter rudder steering angle
is set to 100% and approximately 500º/second high pirouette
speed. Therefore, initially set the transmitter rudder steering
angle to a low value so that the tail can be safely controlled.
(About 70%)
The pirouette speed is proportional to the rudder steering
amount without regard to the gyro sensitivity.