Futaba GY601 - Manual (Page 38)

38
I
NSTALLATION AND
A
DJUSTMENT
(If necessary)
6
When you sense a difference in the rudder effect between the
AVCS and Normal modes, adjust using the GY601 rudder control
gain.
5
Adjust the hovering and flight rudder effect using the transmitter's
D/R or AFR function.
•Do not adjust with the ATV function. If the ATV function is used,
trimming may change.
•Adjustment method
When the rudder effect in the AVCS is different from the rudder effect
in the Normal mode after adjustment was performed using the
transmitter's D/R or AFR function, adjust the difference using the
NCGx parameter.
7
Adjust the left and right pirouette stopping state by control delay
and tracking.
•Adjustment using the delay function of the T9Z transmitter is also
possible. Since the gyro gain also has a large effect on the stopping
state, make this adjustment after adjusting the sensitivity.
8
Adjust the rudder operation feel using the GY601 AVCS sense in
the AVCS mode.
(Steering angle, neutral suppression, and pirouette stopping)