Helpful hinu (confd) 49 – Philips CCZ192AT User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Helpful Hinu (confd) 49
The remote control is not available, or the remote control will not access the pop up menu.
• Use the buttons on the front panel of theTV/VCR to access the pop up menu (page 20).You can not
enter numbers (for example, to program a timer recording) using the front panel buttons.
TV/VCR has no povrer.
• Make sure the power plug is completely connected to an AC (alternating current) outlet
TV/VCR power shuts off after 15 minutes.
• To save ener^, the TV/VCR will shut itself off after 15 minutes when it is on a channel that is not receiv
ing a broadcast signal (for example, a station that has gone off the air for the night).This is normal.
Channel reception is poor.
• Check connections, then set up the channels again (page 10).
TV/VCR does not have a picture.
• Adjust the antenna (page six).
• Adjust theTV/VCR picture controls (pages 24 - 25).
TV/VCR has poor sound or no sound.
• Adjust the volume.
• Press the MUTE button to restore the volume.
Tape playback is poor or tape is destroyed.
• Adjust the tracking. Detaik are on page 45.
• If moisture has accumulated in your TV/VCR, keep the povrer on for at least two hours, but do not try
to play a tape. Detoib are on page 48.
TV/VCR does not display closed captions.
• Make sure Counter Only is set to OFF. Details are on poge 26.
• Make sure closed captioning is available for the program. Refer to the TV listings in your local newspaper.
Remote control does not operate TV/VCR.
• Aim the remote control direaly at theTV/VCR’s remote sensor. Details are on pages (tve and 20.
• Remove all obstacles between the remote control and theTV/VCR.
• Inspect and replace the batteries in the remote control. Detoi/s are on page five.
Number buttons won’t work for channels above 69.
• Select CABLE from the INPUT section of the pop up menu, then let theTV/VCR set up the channels.
Details are on page 10.
TV/VCR can’t receive channels above 13.
• Select CABLE from the INPUT section of the pop up menu, then let theTV/VCR set up the channels.
Details are on page 10.
A tape can’t be inserted into the TV/VCR.
• Insert the tape window side up, with the record tab lacing you.
. Make sure a tape isn’t already in theTV/VCR by pressing the STOP/EJECT button on theTV/VCR.
• Gently push on the center of the tape. Never force a tape into theTV/VCR.
• if a timer recording is set and theTV/VCR power is off, theTV/VCR will eject the tape if the record tab
is missing.
A tape can’t be removed from theTV/VCR.
• Make sure the power plug is completely connected to an AC (alternating current) outlet.
• If a timer recording is programmed, turn on theTV/VCR power,then eject the tape. Be sure to insert a
tape and turn off theTV/VCR power for the timer recording.
TV/VCR ejects the tape when you try to start a recording.
• Make sure the tape has a record tab. Detoi/s are on page five.
The cylinder rotates when tape playback is stopped.
• To enable the quick play mechanism, the cylinder will rotate for about five minutes.This is normal.The
quick play mechanism switches the tape mechanism from Stop to Play in just one second.