Canon 50 User Manual
Page 139
139
T
ro
uble?
E
Memory Card Operation
Printing
Editing
The tape stops during
playback pause.
When playback pause continues for more than 4 minutes 30
seconds during playback or audio dubbing, the camcorder
shuts off to protect tape and video heads. Playback the tape
again and press the
/
pause button.
–
Problem
Solution
Memory card cannot be
inserted.
Memory card was not facing the correct direction. Turn the
memory card over and reinsert it.
22
Memory card cannot be
recorded.
Insert a memory card.
22
Memory card is full. Replace the memory card or erase
images.
104
Memory card is not formatted. Format the memory card.
105
File number reached maximum value. Set [FILE NOS.] to
[RESET] and insert a new memory card.
73
SD Memory Card is protected. Change the position of the
protect switch.
22
Memory card cannot be
played back.
Set the camcorder to CARD PLAY mode.
41
Insert a memory card.
22
Image cannot be erased.
Image is protected. Cancel the protection.
103
SD memory card is protected. Change the position of the
protect switch.
22
“
” flashes red.
Card error occurred. Turn off the camcorder. Remove and
reinsert the memory card. Format the memory card if flashing
persists.
105
Problem
Solution
The printer is not operating
even though camcorder and
printer are correctly
connected.
1. Set the camcorder to CARD PLAY mode.
2. Disconnect and reconnect the USB cable.
3. Turn off the printer and turn it back on.
–
Problem
Solution
Dubbing via the camcorder’s
DV terminal does not work.
Set [AV
DV/
] (OPTURA60) or [AV
DV] (OPTURA50) to
[OFF].
73
Wrong signal format. Dubbing may work via the AV terminal.
Refer also to the instruction manual of the connected device.
–
Problem
Solution