Garelick 48050 050 PREMIUM ROTO MOLDED SEAT & SEAT/PEDESTAL PACKAGE - Manual

Mounting Instructions for
Rotational Molded Poly Seats
Form 12.131
Write for
a Complete
Catalog
Phone: 651-459-9795
PO Box 8, 644 2nd Street E-mail: [email protected]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com
3/98
SWIVEL CASTING ATTACHMENT
Mount Swivel Casting to Reinforcement Brackets by inserting
1/4-20 x 1" Screws (A) through Washers (B), Swivel Casting
and Brackets as shown. Secure with Washers (B) and
Locknuts (C). FINGER TIGHTEN ONLY. Make certain Swivel
Casting’s Locking Rod is directed to side of Seat.
Mount Reinforcement Brackets with Swivel Casting to Seat
Bottom with 1/4-20 x 1/2" Screws (D) and tighten.
Using an open-end wrench and phillips-head screwdriver,
finish securing Swivel Casting to Brackets.
SEAT SLIDE ATTACHMENT
Attach the slide by aligning the matching holes in the seat
bottom; secure with appropriate 1/4-20 machine screws.
NOTE: The portion of the screw entering the seat should not
exceed 3/8 inch.
GIMBAL ATTACHMENT
When mounting an EEz-In Model 75011 gimbal to seat, use
the T-nutted holes as illustrated and attach gimbal with
1/4-20 x 1/2" machine screws.
CARE AND MAINTENANCE
This rotational molded poly seat and cushions can be cleaned
with mild soap and a non-abrasive sponge or cloth.
Periodically tighten screws on seat bottom.