Garelick 75640 QUICK RELEASE TABLE PEDESTAL SYSTEM - Manual

Deck Ring
(4 mounting
locations)
3 1/4"
3"
(Mounts to deck / floor)
Deck Mount
Assembly
HARDWARE INSTALLATION DEPICTION
Keyway
TYPICAL SURFACE MOUNT TABLE
Stanchion
Surface Mount
(Mounts to Table)
Deck Ring
Clamp
4. Push down on clamp to lock,
lift up on clamp to open.
3. Rotate to adjust
clamping pressure
Operating Instructions:
6.
locking position.
Installation Instructions:
for use.
2. Rotate the assembly to the
Hardware Required:
Mounting hardware has not been provided. It is
recommended that 1/4" to 5/16" stainless steel
screws of sufficient length be used. When
mounting items to a deck, bolting through the
deck is recommended.
Deck Ring:
Determine the desired location of the 1.
deck ring. Using the deck ring as a
template, mark the position of the fasteners.
CAUTION: Insure area under the
deck, directly below the marked holes
is free from obstacles such as fuel
tanks, hoses, electrical wires, etc.
Using the marks from step 1, drill holes 2.
and secure the deck ring with appropiate
fasteners.
Make sure socket area is clean and ready
3.
for use.
Surface Mount:
Determine the desired location of the surface 4.
mount on the table bottom surface. Using
the surface mount as a template, mark the
position of the fasteners.
Using the marks from step 4, drill pilot holes
5.
and secure the surface mount with appropiate
fasteners.
CAUTION: Insure when drilling and
fastening hardware that items do not
penetrate the top surface of the table.
Make sure socket area is clean and ready
1. Insert the deck mount assembly
into the deck ring keyways.
Write for
Website: www. garelick.com
Installation Instructions for
Surface Mount Table Hardware
Form 12.552
Catalog St. Paul Park, Minnesota 55071
644 2nd Street, PO Box 8 a Complete
Phone: 651-459-9795
E-mail: [email protected]
07/05
5 3/4"
60°
Surface Mount
(6 mounting
locations)