Garelick 22000 SEAT SLIDE SYSTEM - Manual

Installation and Operating Instructions for
Model 20000/20001/21000/
21001/22000 Seat Slide System
Form 12.331
Write for
a Complete
Catalog
Phone: 651-459-9795
PO Box 8, 644 2nd Street E-mail: [email protected]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com
1/03
INSTALLATION
Read instructions completely before installing. Refer to Fig. 1.
1. Position Seat Slide on seat bottom and align 4 mounting
holes.
2. Secure Seat Slide with appropriate hardware.
NOTE: Fasteners are not provided due to the wide variety
of installations.
NOTE: All EEz-In seats use 1/4"-20 threaded T-nuts.
SPECIAL NOTE: for rotational molded EEz-In seats:
A. Remove the reinforcement brackets from the seat bottom
prior to installation.
B. Make certain that the portion of the screw entering the
seat shell’s T-Nut does not exceed 3/8". Seat shell T-nuts
are 1/4"-20 thread, use only 1/4"-20 machine screws.
3. Remove black delrin cup from swivel casting. Align
splines in cup with splines on seat pedestal and tap on
with a soft hammer, if necessary.
4. Slip seat with slide onto pedestal.
SMOOTH TUBE INSTALLATION
Read instructions completely before installing. Refer to Fig. 2.
1. Slide Delrin Cup (59.858) over stanchion tube. Align
one of three countersunk holes to front of the tube. This
will index casting so seat will lock in the forward facing
position. Push down until rim of cup contacts top of tube.
Center punch tube at locations of three countersunk
holes.
2. Drill three holes 13/64" diameter through tube. File or
scrape clean the burrs left from drilling.
3. Fasten cup in place using three flathead screws (03.547)
and locknuts (03.027).
99301 INSTALLATION INSTRUCTIONS
Read instructions completely before installing. Refer to Fig. 1.
1. Mount the seat and slide assembly on the pedestal. Slip
06.045 cup catch over rib in the casting directly under
the cam handle. Secure with 10-24 x 3/4" screw and
locknut.
(continued on back)
FIG. 1
FIG. 2