Garelick 79715 3.5 GAS RISE COMMANDER SEAT - Manual

Installation and Operation Instructions for
Commander Series Seat Hardware
Form 12.489
WARNING
AVOID SERIOUS OR FATAL INJURY DUE TO
ROTATION OF SEAT.
LOCK SWIVEL WHEN SPEED EXCEEDS 5 M.P.H.
OPERATION:
To Slide Seat:
Pull right rear knob out and slide seat to desired location. Release
knob; it will self lock in position.
To Swivel Seat:
45 Degree Auto Lock Mode
Pull right knob out. Rotate seat to desired
location. Release knob; it will self-lock in position at 45 degree
increments.
Free Rotation Mode
Pull right knob out and rotate the knob 90
degrees clockwise. Release knob. The seat will rotate freely. Rotate
knob 90 degrees counterclockwise to re-engage locking system.
To Adjust Seat Height:
Upward
Note:
This adjustment must be made when the seat is unoccupied.
Loosen cam lock by pulling the handle outward. (Cam lock is located
on the outer tube with the handle in front).
Pull the height adjustment lever located on the left side upward.
The seat will rise. Release lever to lock-in desired position. It may be
necessary to assist the seat upward depending on the seat’s location
with respect to its fore and aft position.
Push cam lock handle back to its original position.
Downward
Loosen cam lock by pulling the handle outward. (Cam lock is located
on the outer tube with the handle in front.)
Pull the height adjustment lever located on the left side upward while
remaining seated. When the desired height is achieved, release the
lever. The seat will remain at that height.
Push cam lock handle back to its original position.
Refer to Figure 1A.
LUBRICATION:
For ease of operation, it is recommended that the horizontal slide
action and vertical rise action be periodically lubricated with a light
lubricating oil. Refer to Figure 1A and note three oil ports and the slide
and swivel locks in Figure 2.
MAINTENANCE:
As with all marine hardware installations, it is recommended that any
exposed fasteners be periodically inspected for security. Any loose
screws should be tightened with the appropriate tool.
Note: Clean only with warm soapy water. Never use harsh cleaners or
petroleum products.
FIG. 1
FIG. 2
Write for
a Complete
Catalog
Phone: 651-459-9795
PO Box 8, 644 2nd Street E-mail: [email protected]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com
5/04
FIG. 1A
!
Screws “G”