60 vehicle care – GMC 2012 Acadia User Manual

Page 366

Advertising
background image

Black plate (60,1)

GMC Acadia/Acadia Denali Owner Manual - 2012

10-60

Vehicle Care

9. Press the on/off button (B) to

turn the tire sealant and
compressor kit on.

The compressor will inject
sealant and air into the tire.

The pressure gauge (C) will
initially show a high pressure
while the compressor pushes the
sealant into the tire. Once the
sealant is completely dispersed
into the tire, the pressure will
quickly drop and start to rise
again as the tire inflates with
air only.

10. Inflate the tire to the

recommended inflation
pressure using the pressure
gauge (C). The recommended
inflation pressure can be found
on the Tire and Loading
Information label. See Tire
Pressure on page 10‑42
.

The pressure gauge (C) may
read higher than the actual tire
pressure while the compressor
is on. Turn the compressor off
to get an accurate pressure
reading. The compressor may
be turned on/off until the
correct pressure is reached.

Notice: If the recommended
pressure cannot be reached after
approximately 25 minutes, the
vehicle should not be driven
farther. The tire is too severely
damaged and the tire sealant and
compressor kit cannot inflate the
tire. Remove the power plug from
the accessory power outlet and
unscrew the inflating hose from
the tire valve. See Roadside
Assistance Program (U.S. and
Canada) on page 13‑7
or
Roadside Assistance Program
(Mexico) on page 13‑9
.

11. Press the on/off button (B) to

turn the tire sealant and
compressor kit off.

The tire is not sealed and will
continue to leak air until the
vehicle is driven and the
sealant is distributed in the tire;
therefore, Steps 12 through
18 must be done immediately
after Step 11.

Be careful while handling the
tire sealant and compressor kit
as it could be warm after
usage.

12. Unplug the power plug (H) from

the accessory power outlet in
the vehicle.

13. Turn the sealant/air hose (F)

counterclockwise to remove it
from the tire valve stem.

14. Replace the tire valve

stem cap.

15. Replace the sealant/air

hose (F), and the power plug
(H) back in their original
location.

Advertising