Grant Instruments XUB Series - Manual (Page 6)

XUB Series 29666 V1
Operating Manual
4
Fill Line
Quick guide
Pour cold water into the bath so that it reaches the minimum tank fill line (but does not
go over the maximum fill line).
Add the required dose of detergent (see page 22).
Switch on the machine via the switch at the rear of the unit, just above the electrical
mains lead.
Press the “START” key to accept the programmed cleaning cycle settings and start
the cleaning cycle.
At the end of the cleaning cycle, remove the basket from the bath and rinse the
cleaned items under clean running water. The lid can be inverted and the basket
placed on top to catch excess fluid as the items dry.
REMEMBER
- Always keep the bath full of liquid when in operation
- Do not put hot water above 50°C into the bath
- Always use the basket
- Never expose hands, fingers or other body parts to cleaning solutions
- Never use toxic, flammable, acidic, caustic or corrosive solutions
- Never breathe the fumes from strong solutions
- Rinse the items in clean water once the cycle is complete
Subjecting the bath to improper treatment or misuse will invalidate the warranty.