Great Planes SPAD XIII EP WWI Parkflyer ARF - GPMA1143 - Manual (Page 11)

11
❏
7. Plug the elevator and rudder servos into their proper
channels on the receiver. Plug the ESC into the receiver.
Mount the receiver in the airplane as shown. Route the
antenna out of the fuselage and tape it to the lower fuse near
the opening where the tail skid will mount. NOTE: On Futaba
radios, Channel 2 is the elevator, Channel 3 is the ESC, and
Channel 4 is the rudder.
❏
8. Insert the 1 x 550mm elevator and rudder pushrods into
the pushrod guide tubes as shown. Do not attach these to
the servos yet.
❏
9. Find the pushrod support and position it in the fuse as
shown. Do not glue it in place yet. Route the antenna and the
ESC signal lead through the right side of the support. Route
the ESC motor leads and the aileron Y-harness through the
left side as shown.
❏
10. Slide the elevator and rudder pushrods through
the pushrod support and into the Screw-Lock ™ pushrod
connectors on the servos. Adjust the vertical position of
the pushrod support until the pushrods are centered in the
support holes. When you are satisfi ed, glue the support
to the back side of the fuselage bulkhead. NOTE: Do not
tighten the screws on the pushrod connectors.