Great Planes SPAD XIII EP WWI Parkflyer ARF - GPMA1143 - Manual (Page 15)

15
❏
2. Test fi t the cabane struts to the fuselage as shown. Use
a 1/16" [1.6mm] drill bit to drill a hole for the screw where
shown. NOTE: Gluing these in place is optional and can be
done after you are assured of a proper fi t of the upper wing.
❏
3. Install the upper wing using six 2 x 7mm sheet metal
screws. Install two 2 x 7mm sheet metal screws in the lower
legs of the forward cabanes.
❏
4. Route the aileron servo leads through the slot in the
fuselage. Use a tie strap to secure them to the cabane strut.
❏
5. Connect the aileron leads to the Y-harness. Use a
drop of glue to attach the aileron Y-harness to the fuse side.
Place it in a location that will neatly keep wires away from
the pushrods.
❏
6. Use a 4-40 x 3/4" machine screw and washer to attach
the lower wing to the fuse.
❏
7. Attach the interplane wing struts to the lower wing.