Great Planes SPAD XIII EP WWI Parkflyer ARF - GPMA1143 - Manual (Page 14)

❏ ❏
7. Install a Screw-Lock pushrod connector in the outer
hole of each aileron control horn. Position the connector
body on the outboard side of the horn. Secure it to the horn
with a plastic retainer, placing a 2mm washer between the
horn and the retainer.
❏ ❏
8. Install a 1 x 65mm Z-bend pushrod through the
outer hole of each aileron servo arm. Connect the pushrods
to the ailerons.
Install the Strut Mounts
A
FORWARD
Upper Wing x 12
Lower Wing x 4 Lower Wing x 4
B C
❏
1. Locate the twelve strut mounts marked “A.” Test fi t
these in the bottom of the top wing as shown. When you’re
satisfi ed with the fi t, glue these to the wing using thin CA.
❏
2. Install the four strut mounts marked “B” in the top of the
lower wing in the LE slots. Use the sketch above to help you
orient these properly before you glue them. Install the “C”
strut mounts in the TE slots of the lower wing.
INSTALL THE WINGS
❏
1. Prepare the eight interplane wing struts as shown using
sixteen 2 x 7mm sheet metal screws. Attach the interplane
wing struts to the upper wing on the outboard side of each
strut mount. Do not tighten the struts yet.
14