Great Planes SPAD XIII EP WWI Parkflyer ARF - GPMA1143 - Manual (Page 16)

16
INSTALL THE LANDING GEAR
❏
1. Locate two 3 x 25mm fi ne thread machine screws
and four 3mm nuts. Apply thread locking compound to each
screw and install each to a wheel using one 3mm nut. To
achieve the proper spacing, turn the nut until it contacts the
wheel and then back it off 1/2 of a turn.
❏
2. Install a wheel and axle assembly to each landing gear
leg using a 3mm nut. Hold the outboard nut while you tighten
the inboard nut.
❏
3. Use four 2-56 x 3/8" machine screws and four small
washers to attach the landing gear legs to the bottom wing.
❏
4. Install the 4 x 150mm axle tube.
❏
5. Install the tail skid using your choice of glue.