Great Planes VFO ARF EP Aerobat - GPMA1135 - Manual (Page 10)

10
❏
7. Plug your servos into the appropriate channels and
route your receiver antenna.
Before we go any further in the assembly process, you need
to set up the mixing required to fl y the model. We explain this
on page 12, “Mixing Set Up”. After you have the radio set up
with the correct mixing, proceed with the next step.
❏
8. The control rods are made up of eight 5/64" [2mm]
pre-bent steel wires, four 5/64" [2mm] carbon rods and eight
pieces of heat shrink tubing.
❏
9. With the servo centered, install one of the metal control
wires into the outer hole in the servo arm and one in the
second hole from the end of the control horn in the control