Great Planes VFO ARF EP Aerobat - GPMA1135 - Manual (Page 8)

8
❏
3. Secure the motor to the mount with three 1/8" x 3/8"
[3mm x 10mm] screws.
❏
4. From one of the two 4" [102mm] Velcro strips, cut 1"
[25mm].
❏
5. From the larger piece of the Velcro you cut, apply one
half of the Velcro so that the top edge of the Velcro is 2"
[51mm] below the bottom edge of the painted black nose.
The other half of Velcro is applied to the back of your battery.
The Velcro secures the battery to the fuselage.
❏
6. Plug the wires from your motor and ESC together.
Apply the 1" [25mm] piece of Velcro to the back of the ESC
and then apply it to the fuselage. To keep the wires in place
against the fuselage side, you may wish to use a bit of hot
melt glue or tape.
INSTALL the SERVOS, PUSHRODS
and CONTROL HORNS
❏
1. For adequate control movement you will need a
minimum 1" [25mm] servo arm.
❏
2. Center the servo and then install the servo arm onto the
servo as shown. Drill out the outer two holes in the control
horn with a #57 or .043 drill bit.