Great Planes VFO ARF EP Aerobat - GPMA1135 - Manual (Page 5)

5
❏
3. Each of the control surfaces comes pre-taped. The
tape partially covers the slot in the control surface. Use a
hobby knife to cut the tape that covers the slot.
❏
4. Glue the triangles in place onto both sides of each
control surface. Be sure the slots in the triangles align with
the slot in each control surface.
❏
5. Remove the small triangles from the foam sheet.
❏
6. Glue a triangle onto each side of each of the four
fuselage parts. The triangle is glued to the trailing edge of
the fuselage side where shown.