Great Planes VFO ARF EP Aerobat - GPMA1135 - Manual (Page 9)

9
Before proceeding, look at these two pictures to understand
the orientation for the servo as it is fi t into the servo mounting
hole.
❏
3. Position the servo against the servo opening. Make
marks on the fuselage where the servo mounting tabs contact
the fuselage. Cut the foam on those marks. Slide the servo
into the slots you cut. For now, leave the servo in the opening
secured only with the friction of the foam. You will permanently
mount the servos to the fuselage in a future step.
❏ ❏ ❏
4. Repeat steps 2 and 3 for the remaining three
servos.
❏
5. The servo leads need to be routed to the side of the
fuselage where the speed control is mounted. The wires
pass through the small square openings in the fuselage.
❏
6. From the remaining Velcro, cut a piece large enough to
fi t your receiver. Install the receiver to the fuselage making
sure that you position it so the wire leads from the ESC and
the servos can reach the receiver without the use of any
servo extensions.