Great Planes VFO ARF EP Aerobat - GPMA1135 - Manual (Page 6)

6
❏
7. Lay the two wing halves side by side and then glue
them together with medium or thick CA. Hold the two halves
tightly together until the glue has cured.
❏
8. Glue the top half of the fuselage to the top of the wing
with medium or thick CA. After the glue has cured repeat this
step for the bottom half of the fuselage.
❏
9. Remove the black motor mount doublers from the
foam sheet they are attached to. Examine them closely. Four
doublers are shorter than the other four. Separate them into
four long and four short doublers.
❏
10. Glue one of the long doublers in place on the front
of one of the fuselage sides. Glue a shorter doubler to the
fuselage side next to it.
L
L
L
L
S
S
S
S
❏
11. Repeat step 10 until all of the doublers are glued
into place.
❏
12. Locate four 1/4" x 3" [6mm x 76mm] carbon fi ber
strips. Glue them to the bottom of each of the orange and
black fuselage pods.
❏
13. Glue the orange pods to the orange wing tips and the
black pods to the black wing tips.