Heli-Max HMXE0832 - Manual (Page 13)

13
This procedure should be used if the return speed of the 1Si needs to be
changed.
1. Enter the Adjustment Mode as described earlier.
2. Push the rudder trim button to the left increase the return speed. The
longer the button is held to the left, the LED on the 1Si will fl ash faster
and the tone will increase in pitch to indicate that a higher return speed is
being selected. When the LED remains steady, the highest speed has been
selected. Moving the button to the right will reduce the return speed. The
LED will fl ash slower and the pitch will be lower to indicate the speed that is
being selected. When the LED turns off, the lowest speed has been selected.
3. Press down on the left stick to exit the Adjustment Mode when the desired
speed has been selected.
®
CAMERA OPERATION CAMERA OPERATION
The camera will be in VIDEO mode when it is fi rst powered up. Press the
VIDEO button to start recording a video. You will see the LED on the side of
the camera fl ash slowly while the video is being captured. To stop recording
and store the video, press the VIDEO button again. The LED will stop fl ashing
to indicate that the camera is ready for use. If the card is removed or the
battery unplugged while the camera is recording, the video will NOT be
saved on the card.
Before the camera can take a photo, it must be in the Picture mode. Press
the PICTURE button one time, to change the mode. The LED on the camera
will remain steady while the camera mode is changed. Press the PICTURE
button to take a photo. You will notice that the LED will fl ash rapidly as the
picture is recorded and stored on the microSD card. When the LED stops
fl ashing, the camera is ready to take another photo. If the Picture button is
pressed while the LED is fl ashing, the camera will not capture another photo.
The VIDEO button must be pressed once to change modes before the camera
will capture a video.
Installing the MicroSD Card
To minimize any chance of data being lost
on the microSD card, do not insert or remove
the card from the camera until the battery
has been unplugged from the quadcopter.
Remove the SD card from the protective
case. Flip the model over and push the card
into the slot on the side of the camera
module. When the card is correctly installed,
it will click. To remove the card, simply press