Heli-Max HMXE0832 - Manual (Page 14)

14
on the card again and the inner spring system will help eject the card. Note:
The card must be in place to capture video or Pictures. The camera has no
internal memory.
Downloading the video and pictures from the camera:
Install the MicroSD card into the reader.
Plug the reader into the USB port of
your computer.
The USB connection will be auto
recognized and the files ready to be
transferred.
At this point you can copy or transfer
your files to your folder structure.
®
TROUBLESHOOTING TROUBLESHOOTING
PROBLEM: 1Si does not react to any stick movements.
Solution 1: Make sure that the battery voltage is above 4.0 volts
Solution 2: If the LED on the rear of the model is not steady, unplug the
battery and turn off the transmitter to allow the control board to reset itself.
After about a minute, turn on the transmitter and reconnect the battery.
PROBLEM: Flies with poor power or buzzes.
Solution: One of the props may be bent. Carefully bend it straight.
PROBLEM: You notice that one of the motors spins noticeably slower
or feels tight.
Solution: Replace the motor. This is done by removing all 4 props and
loosening the screws holding the frame together. Remove the top of
the frame and unplug the defective motor wire from the control board.
The LED board can be popped off the alignment posts with a small
screwdriver. The motor will slide out of the frame and the new motor/
LED board can now be installed. A couple of small pieces of tape will
hold the LED board in place.
PROBLEM: The 1SI will not return directly to you in Auto Return mode.
Solution: Calibrate the transmitter and or the control board.