Heli-Max HMXE0832 - Manual (Page 6)

6
Charge Warnings
● Only use the included charger with the included LiPo battery.
Do not attempt to use the provided charger with NiCd, NiMH
or batteries with other chemistries.
● Do not leave the charger unattended while in use and always charge your
battery in a fi re-resistant location.
● Disconnect the battery and remove input power from the charger immediately
if either becomes hot!
● Do not allow water or other foreign objects to enter the charger. Keep the
charger away from moisture and do not submerge in water.
● Please keep all electronic components out of the reach of children!
®
BATTERY CHARGING BATTERY CHARGING
● WARNING!! The charger supplied with the Heli-Max 1Si
Quadcopter contains protective circuitry. If you experience any
difficulties while charging the battery, please disconnect the
battery from the charger and unplug the charger from the power
source. Allow the battery and charger to rest for two hours as this will allow
the charge protection circuit to reset. If this issue re-occurs during normal
use, please contact technical support for further assistance.
❏
Plug the flight battery into the end
of the USB charger.
❏
Plug charger into a USB port. A
steady red light will glow letting you
know the battery is charging. The light
will flash slowly when the charge is
complete. Remove the battery from
the charger. Under normal operating
conditions, the battery may take up to
60 minutes to recharge. Never leave
the battery attached to the charger
after charging is complete.
NOTE: A fast flash indicates a charge error. This is usually an indication that
your battery is defective and should be replaced.