Heli-Max HMXE07 - Manual (Page 13)

13
SERVO SETUP
Note: The AXE CP V3 RTF is factory set-up and test fl own
so there is no need to make these adjustments unless you
have damaged or changed a servo.
Servo arms are perfectly level when the throttle stick is all
the way down in normal mode (Idle Up Off). Helicopter left
side Servo A pushrod length should be 1.77" [45mm].
Servo arms are perfectly level when the throttle stick is all
the way down in normal mode (Idle Up OFF). Helicopter right
side Servo B pushrod length should be 1.26" [32mm] and
Servo C pushrod length should be 1.77" [45mm].
TAIL ROTOR REPLACEMENT
Use two small fl at bladed screwdrivers to pry the old tail rotor
from the motor. Try to apply even pressure to both sides of
the tail rotor. When installing the new tail rotor please note
that the beveled portion of the hub goes in towards the motor.
Simply press the new propeller onto the tail motor.
SPINDLE REPLACEMENT
Before starting, make note of the 2mm nut used on the
bottom of each blade grip. When removing the blade bolt,
press upward on the nut to ensure it remains in the grip.
Remove the blade grip bolts using the 1.5mm hex wrench.
Then, remove the blades from the helicopter
Use a 1.5mm hex wrench to remove a spindle screw. Remove
the linkages from the blade grips. On the side where you
removed the spindle screw, carefully remove the blade grip