Heli-Max HMXE07 - Manual (Page 16)

16
Solder a Micro Deans plug onto the motor wires of the C-
12 ESC as shown. The negative (–) motor lead (blue wire)
connects to the male pin on the connector. This will be
connected to the tail motor in a later step.
It will be necessary to solder the E-Board and C-12 ESC to
the battery connector as shown above. If you decide to use
the Great Planes 950mAh LiPo battery (GPMP0401), we
suggest installing a Deans Ultra Male Plug onto the ESC and
E-Board to match the connector on the battery pack. The
Deans Ultra Plug will better handle the increased current
draw of more aggressive fl ight as your skill level advances.
Using wire cutters, remove the Deans Micro connector from
both battery input leads on the E-Board and the C-12 ESC.
Remove 1/4" [6mm] of wire insulation from both the positive
(+) and negative (–) leads of the C-12 ESC and E-Board.
Compare the battery pack connector to the ESC connector
and verify the polarity is correct before soldering. Twist and
solder together the positive battery lead from the C-12 ESC
and the positive lead from the E-Board. Slide the supplied
heat-shrink tubing (included with the Deans Ultra Plug) over
the wires and solder them to the Deans connector. Repeat
for the negative lead. Slide the heat-shrink tubing up the wire
to the plug. Use heat to shrink the tubing.
Disconnect the tail motor plug as shown above and connect
the plug directly into the blue and white motor wires on the
C-12 ESC.