Heli-Max HMXE07 - Manual (Page 5)

5
ASSEMBLY INSTRUCTIONS
INSTALL BATTERIES IN THE TRANSMITTER
❏
1. Remove the battery cover from the back of the transmitter.
Remove the battery box and install eight “AA” batteries in the
transmitter. Check the polarity of each battery before replacing
the battery cover.
❏
2. Turn on the transmitter using the power switch as shown
above. Check the LEDs on the front of the transmitter. Only
the Green LED should be on. If the Red LED is on or fl ashing,
then the batteries need replacing.
CHARGING THE FLIGHT BATTERY
IMPORTANT!! Always remove the LiPo battery pack
from the helicopter and charge the battery in a location
that is fi reproof. Never leave the battery unattended
while being charged! If the battery becomes hot, starts
to smoke or begins to swell immediately disconnect the
battery from the charger and carefully move the battery
to a fi reproof location!
❏
1. Connect the input power plug from the AC Wall adapter
to the charger. The power light should now be bright red and
the charger indicator light should be off.
❏
2. Always use the charge and balance connector on the
battery when charging. Do not use the discharge connector
to charge the battery!
❏
3. Connect the battery to the balance connector on the
charger. The charge indicator light will turn to red, indicating