Heli-Max HMXE05 - Manual (Page 5)

5
Install Batteries in the Transmitter
❏
Remove the battery cover from the back of the
transmitter, remove the battery box and install eight “AA”
batteries in the transmitter. Double-check the polarity of
each battery before replacing the battery cover.
❏
Insert the transmitter antenna into the top of the
transmitter and turn it clockwise until it is tight.
❏
Turn on the transmitter using the power switch as shown
above. Check the LEDs on the front of the transmitter. Only
the Green LED should be on. If the Red LED is on, then the
batteries need replacing. Turn the transmitter off for now.
Assemble Training Gear
❏
Slide the four landing gear clips onto the training gear
legs as shown. Install the four training gear legs into the
training gear base. Align the clips up with the skids and
install the training gear onto the helicopter.
WARNING!! Read the entire instruction sheet included
with this battery. Failure to follow all instructions could
cause permanent damage to the battery and its
surroundings, and cause bodily harm!
• ONLY use a LiPo approved charger. NEVER use a
NiCd/NiMH peak charger!
• NEVER charge in excess of 4.20V per cell.
• NEVER charge at currents greater than 1C.
• ALWAYS set charger’s output volts to match battery volts.
• ALWAYS charge in a fireproof location.
• NEVER trickle charge.
• NEVER allow the battery temperature to exceed 150° F
[65° C].
• NEVER disassemble or modify pack wiring in any way or
puncture cells.
• NEVER discharge below 2.5V per cell.
• NEVER place on combustible materials or leave
unattended during charge or discharge.
• ALWAYS KEEP OUT OF REACH OF CHILDREN.
LITHIUM BATTERY HANDLING & USAGE
ASSEMBLY INSTRUCTIONS