Heli-Max HMXE0806 - Manual (Page 13)

13
❏
Your Novus helicopter uses a 2.4GHz system that requires linking the
transmitter to the receiver when the unit is powered up. With the transmitter
turned off, connect the fl ight battery to the helicopter. Then place the model on a
fl at surface and turn the transmitter on. You will notice that the trim tab indicators
are moving. This is an indication of the linking process. Allow the helicopter to
remain still and do not move the transmitter sticks during the linking process.
❏
Two loud tones will be emitted from the transmitter and the swashplate servos
will move to the correct positions. Continue to allow the helicopter to sit still.
After a couple of seconds two faint tones will be emitted from the helicopter. This
indicates that the gyro has initialized and the linking process is now complete.
Your Novus Helicopter is now ready for fl ight. Always step 15 feet [4.5m] away
from the Novus Helicopter before operating the throttle.
Your Novus helicopter has a safe start feature built in that prevents
the motor from activating unless the collective stick has been lowered
to the lowest position. If the motor won’t run and turn the main blades,
please make sure the collective stick is all the way down and leave it
there for a couple of seconds. Then try moving the stick up slowly.