HONDA 2014 CR-V - Owner's Manual - Manual (Page 117)

uu Operating the Switches Around the Steering Wheel u Wipers and Washers
116
Co
ntrols
The rear wiper and washer can be used when
the ignition switch is in ON
( w .
■ Wiper switch (OFF, INT, ON)
Change the wiper switch setting according to
the amount of rain.
■
Washer ( )
Sprays while you rotate the switch to this
position.
Hold it to activate the wiper and to spray the
washer. Once released, it stops operating
after a few more sweeps.
■
Operating in reverse
When you shift the transmission to ( R with the windshield wipers activated, the rear
wiper operates automatically as follows even if its switch is off.
■ Rear Wiper/Washer 1 Wipers and Washers
If the wiper stops operating due to any obstacle such
as the build-up of snow, park the vehicle in a safe
place. Rotate the wiper switch to OFF, and turn the
ignition switch to ACCESSORY
( q or LOCK ( 0, then
remove the obstacle.
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes, once the
circuit has returned to normal.
INT: Intermittent
OFF
ON: Continuous wipe
Washer
Front Wiper Position Rear Wiper Operation
INT (Intermittent) Intermittent
LO (Low speed wipe)
HI (High speed wipe)
Continuous
14 CR-V-31T0A6200.book 116 ページ ２０１４年２月１０日 月曜日 午後７時１分