HONDA 2014 CR-V - Owner's Manual - Manual (Page 118)

117
uu Operating the Switches Around the Steering Wheel u Brightness Control
Co
ntrols
Brightness Control
When the parking lights are turned on and the
ignition switch is in ON
( w , you can use the
brightness control knob to adjust instrument
panel brightness.
Brighten: Turn the knob to the right.
Dim: Turn the knob to the left.
You will hear a beep when the brightness
reaches minimum or maximum. The
information display will return to its original
state several seconds after you adjust the
brightness.
■ Brightness level indicator
The brightness level is shown on the
information display while you are adjusting it.
1 Brightness Control
Instrument panel brightness differs between when
the exterior lights are on and when they are off. The
instrument panel dims to reduce glare when the
lights are on.
Pressing the (Select/Reset) knob switches the
display.
If you turn the knob to the right until the brightness
display is up to max, the beeper sounds. This cancels
the reduced instrument panel brightness when the
exterior lights are on.
Control Knob
14 CR-V-31T0A6200.book 117 ページ ２０１４年２月１０日 月曜日 午後７時１分