Emissions testing – HONDA 2007 Element - Owner's Manual User Manual

Page 257

Advertising
background image

Without touching the accelerator
pedal, start the engine, and let it
idle for 20 seconds.

If you take your vehicle for an

emissions test shortly after the

battery has been disconnected or

gone dead, it may not pass the test.

This is because of certain " readiness

codes" that must be set in the on-

board diagnostics for the emissions

systems. These codes are erased

when the battery is disconnected,

and set again only after several days

of driving under a variety of

conditions.

If the testing facility determines that
the readiness codes are not set, you
will be requested to return at a later
date to complete the test. If you must
get the vehicle retested within the
next two or three days, you can
condition the vehicle for retesting by
doing the following.

Make sure the fuel tank is nearly,
but not completely full (around
3/4).

Keep the vehicle in Park
(automatic transmission) or
neutral (manual transmission).
Increase the engine speed to 2,000
rpm, and hold it there until the
temperature gauge rises to at least
1/4 of the scale (about 3 minutes).

Make sure the vehicle has been
parked with the engine off for 6
hours or more.

Make sure the ambient
temperature is between 40° and
95°F.

Without touching the accelerator
pedal, start the engine, and let it
idle for 20 seconds.

Testing of Readiness Codes

Emissions Testing

254

Main Menu

Table of Contents

Advertising