HONDA 2005 CR-V - Owner's Manual - Manual (Page 225)

Pull off the center spacer. Using
the wheel wrench, loosen the
three wheel nuts and remove them.
Remove the spare tire from the
holder. Unzip the flap around the lower
edge of the cover.
Pull out the bottom of the cover,
then gradually pull it off.
Loosen each wheel nut 1/2 turn
with the wheel nut wrench.
Place the jack under the jacking
point nearest the tire you need to
change. It is pointed to by an
arrow molded into the underside
of the body. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the center of the jacking
point tab is resting in the jack
notch. 9. 11.
10.
7.
8.
If equipped
Changing a Flat Tire
Hard plastic spare tire cover
222
CENTER SPACER JACKING POINT
NUTS
Main Menu Table of Contents