HONDA 2004 S2000 - Owner's Manual - Manual (Page 134)

CONTINUED
Remove the oil filter, and let the
remaining oil drain. A special
wrench (available from your
Honda dealer) is required.
Install a new oil filter according to
the instructions that come with it.
Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten it to:
Refill the engine with the
recommended oil.
Engine oil change capacity
(including filter):
Let the engine run for several
minutes, then check the drain bolt
and oil filter for leaks.
Open the hood, and remove the
engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.
Install the engine oil fill cap. Start
the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn off the
engine and check your work.
2.
4.
3.
5.
6.
7.
8.
Changing the Oil and Filter
Maintenance 131
WASHER OIL DRAIN BOLT OIL FILTER
33 lbf·ft (45 N·m , 4.6 kgf·m)
5.1 US qt (4.8 )
Main Menu Table of Contents