HONDA 2004 S2000 - Owner's Manual - Manual (Page 143)

Use a small flat-tipped screwdriver
to pry carefully on the back edge
of the side turn signal assembly
until it pops out of the body.
Turn the bulb holder one-quarter
turn counterclockwise to remove it
from the lens.
Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
Put the bulb holder back into its
hole in the lens, and turn it
clockwise until it locks.
Put the side turn signal assembly
back into the body, front first.
Push on the back edge until it
snaps into place.
Test the lights to make sure the
new bulb is working.
1.
2.
3.
4.
5.
6.
Lights
Maintenance
Replacing a Side Turn Signal Bulb
140
Main Menu Table of Contents