HONDA 2000 Passport - Owner's Manual - Manual (Page 220)

Hood Latch and Hinges
Lubricate the hood latch assembly
and hood hinge assembly as
follows:
1. Wipe off any accumulation of
dirt or contamination on the
latch parts.
2. Apply multipurpose-type
grease (NLGI No. 1 or 2) to
the hood latch pin cam.
3. Apply light engine oil to all
pivot points in the release
mechanism.
4. Lubricate hood hinges with
multipurpose-type grease
(NLGI No. 1 or 2).
5. Check the hood hinges and
latch mechanism to assure
they are working correctly.
Air Conditioning
Periodically have your Honda
dealer check your air conditioning
system to be sure there has been
no loss in cooling output. See
your Honda dealer if you suspect
that the system is not performing
as it should.
Body Lubrication
Normal use of a vehicle causes
metal-to-metal movement at certain
points in the body. Noise, wear and
improper operation at these points
will result when a protective film
of lubricant is not provided.
For exposed surfaces such as door
checks, door lock bolts, lock
striker plates, etc., apply a thin
film of light engine oil.
Any lubricant should be used
sparingly. After application, all
excess lubricant should be
carefully wiped off.
The seat adjusters and seat track
should be lubricated with water-
resistant EP chassis lubricant.
There are other points on the
vehicle body which may
occasionally require lubrication.
Window regulators and controls
are confined in the space between
the upholstery and the outside
door panel. Easy access to the
working parts may be made by
removing the trim. Door
weatherstrips and rubber hood
bumpers should be lightly coated
with a rubber lubricant.
Care and Maintenance
Main Menu Table of Contents