HONDA 2000 Passport - Owner's Manual - Manual (Page 224)

chemicals from industrial
chimneys, and other foreign
matter may damage your vehicle's
finish if allowed to remain on
painted surfaces.
Prompt washing may not
completely remove all of these
deposits. Additional cleaners may
be needed. When using chemical
cleaners developed for this
purpose, be certain they are safe
for use on painted surfaces.
Finish Damage
Any stone chips, fractures or deep
scratches in the finish should be
repaired promptly. Exposed metal
will corrode quickly and may
develop into a major repair
expense. Minor chips and scratches
can be repaired using touch-up
materials available from your
Honda dealer.
Corrosion Protection
Your vehicle has been designed
and built to resist corrosion.
Special materials and protective
finishes were applied to most
parts of your vehicle when it was
built to help maintain its good
looks, strength and reliable
operation. However, some parts
that are normally not visible (such
as certain parts under the vehicle
and under the hood) are strong
enough so that surface rust will
not affect their reliability. So
corrosion protection is not needed
or used on these parts. By
omitting unneeded rust protection
on such parts and applying extra
protection where it is needed
most, the best value is assured for
the vehicle buyer.
Sheet Metal Damage
If your vehicle is damaged and
requires sheet metal repair or
replacement, make sure the body
repair shop applies anti-corrosion
material to the parts repaired or
replaced so that corrosion
protection is restored. (Also see
"Finish Damage.")
Underbody Maintenance
Corrosive materials used for ice
and snow removal and dust
control can collect on the
underbody. If these materials are
not removed, accelerated
corrosion (rust) can occur on
underbody parts such as fuel lines,
frame, floor pan, and exhaust
system even though they have
Care and Maintenance
Main Menu Table of Contents