Interlogix NS2503-24P/2C User Manual - Manual (Page 21)

NS2503-24P/2C User Manual
21
Installing the SFP transceiver
This section describes how to plug-in an SFP transceiver into an SFP slot.
The SFP transceivers are hot-swappable. You can plug-in and out the transceiver to/from any SFP port without a need to shut
down the Managed Switch.
Figure 2-7: Plug-in the SFP transceiver
Approved IFS SFP Transceivers
IFS Managed switches support both single mode and multi mode SFP transceivers. Please refer to below chart, as well as IFS
website for latest compatible SFP modules.
1000Base-SX/LX SFP transceiver:
It recommends using IFS SFPs on the Switch. If you insert a SFP transceiver that is not
supported, the Managed Switch will not recognize it.