Document Outline

• Introduction
  • Package Contents
  • Product Description
  • How to Use This Manual
  • Product Features
  • Product Specification
• INSTALLATION
  • Hardware Description
    • Switch Front Panel
    • LED Indications
    • Switch Rear Panel
  • Install the Switch
    • Desktop Installation
    • Rack Mounting
    • Installing the SFP transceiver
• SWITCH MANAGEMENT
  • Requirements
  • Management Access Overview
  • Web Management
  • SNMP-Based Network Management
  • Administration Console
  • Protocols
    • Virtual Terminal Protocols
    • SNMP Protocol
    • Management Architecture
• Web-Based Management
  • About Web-based Management
    • Requirements
    • Logging on the Managed Switch
    • Main WEB PAGE
  • System
    • System Information
    • IP Configuration
    • Console Port Info
    • SNMP Configuration
    • Syslog Setting
    • System Log
    • SNTP Setting
    • Firmware Upgrade
    • Configuration Backup
    • Factory Default
    • System Reboot
  • Port Configuration
    • Port Control
    • Rate Control
    • Port Status
    • Port Statistics
    • Port Sniffer
    • Protect Port
    • Remote Ping
  • VLAN configuration
    • VLAN Overview
    • Static VLAN Configuration
    • Port-based VLAN
    • 802.1Q VLAN
    • GVRP VLAN
    • Q-in-Q VLAN
  • Trunking
    • Aggregator setting
    • Aggregator Information
    • State Activity
  • Forwarding and Filtering
    • Dynamic MAC Table
    • Static MAC Table
    • MAC Filtering
  • IGMP Snooping
    • Theory
    • IGMP Configuration
    • Static Multicast Table
  • Spanning Tree Protocol
    • Theory
    • Illustration of STP
    • STP Parameters
    • STP System Configuration
    • Port Configuration
  • DHCP Relay & Option 82
  • LLDP
    • Port Configuration
    • Per Port Configuration
  • Access Control List
  • Users Configuration
  • MAC Limit
    • MAC Limit Configuration
    • MAC Limit Port Status
  • 802.1X Configuration
    • Understanding IEEE 802.1X Port-Based Authentication
    • System Configuration
    • 802.1x Port Configuration
    • Misc Configuration
  • QoS Configuration
    • Understand QoS
    • QoS Configuration
    • TOS/DSCP
  • Power over Ethernet
    • Power over Ethernet Powered Device
    • NS2503-24P/2C Power Management
    • PoE Schedule
• CONSOLE MANAGEMENT
  • Login in the Console Interface
  • Configure IP address
  • Commands Level
• COMMAND LINE INTERFACE
  • Operation Notice
  • System Commands
  • Switch Static Configuration
    • Port Configuration and show status
  • Trunk Configuration
    • Trunking Commands
    • LACP Command
  • VLAN Configuration
    • Virtual LANs
    • VLAN Mode: Port-based
    • Advanced 802.1Q VLAN Configuration
  • Misc Configuration
  • Administration Configuration
    • Change Username / Password
    • IP Configuration
    • Reboot switch
    • Reset to Default
    • TFTP Update Firmware
    • Restore Configure File
    • Backup Configure File
  • MAC limit
  • Port Mirroring Configuration
  • Quality of Service
    • QoS Configuration
    • Per Port Priority
  • MAC Address Configuration
  • STP/MSTP Commands
  • SNMP
    • System Options
    • Community Strings
    • Trap Managers
  • IGMP
  • 802.1x Protocol
  • Access Control List
    • Ipv4 ACL commands
    • Non-Ipv4 ACL commands
  • Binding
    • SIP/SMAC binding commands
  • Power over Ethernet Commands
    • Display System PoE status
    • Configure PoE Over Temperature Protection
    • Configure PoE -- System
    • Configure PoE -- Port
• SWITCH OPERATION
  • Address Table
  • Learning
  • Forwarding & Filtering
  • Store-and-Forward
  • Auto-Negotiation
• POWER OVER ETHERNET OVERVIEW
  • What is PoE?
  • The PoE Provision Process
    • Stages of powering up a PoE link
    • Line Detection
    • Classification
    • Start-up
    • Operation
    • Power Disconnection Scenarios
• TROUBLE SHOOTING
• Appendix A—RJ-45 Pin Assignment
  • Switch's RJ-45 Pin Assignments
  • 10/100Mbps, 10/100Base-TX
• APPENDIX B: Local User Access Level Table