Interlogix TruVision NVR 10 User Manual User Manual
Page 40
Chapter 5: Recording settings
34
TruVision NVR 10 User Manual
Note: You must set the storage mode of the HDD to Group before configuring
redundancy. See “Setting up HDD groups” on page 58 for more information.
To set up HDD redundancy:
1. Set which cameras will be recorded on which HDD.
From the menu toolbar, click
System Settings
>
Hard Disk
>
Storage Mode
.
Under
Mode
, select
Group
.
Under
Record on HDD Group
, select the HDD group number. Check the channels
to be added to this group.
Note:
By default, all channels belong to HDD group 1.
Click
Apply
to save the settings.
2. Set which HDD will be read/write (R/W) and which HDD will mirror the R/W HDD.
Click the
HDD Information
tab and select the HDD to be used for redundancy and
click
Edit
. In the Local HDD Settings screen, select
Redundancy
. Verify at least
one other HDD is set to R/W.
Click
Apply
to save the settings and then
OK
return to the previous screen.
3. Click
Back
to return to live view.