Interlogix R1075 Series - Manual (Page 2)

R1075 Mini-Max Magnetic Contacts
3
/ 8
" Diameter Press Fit with Wire Leads
Installation Instructions
Switch
1: Drill
3 /
8
" dia. hole 1 1 /
8
" deep for the contact.
2: Connect contact leads to security system loop and test for continuity.
3: Lightly coat the contact RTV mounting compound (Sentrol part number 1905) and insert
into hole.
Magnet
1: Mount magnet to double-sided tape (included) and affix to window frame.
2: Or, if using stainless steel screw (included), drill
1 /
16
" dia. (using magnet center hole
as a guide) and mount using #4 x 1 /
2
" stainless steel screw (included). Use caution if using
screw other than the one provided, as it will effect the gap performance.
3: Care should be taken not to over tighten screw to avoid damaging magnet or stripping hole.
Recess/Flush Mount Magnet
1: Drill
7 /
16
" dia. by approximately 1 /
8
" deep .
2: Coat magnet with RTV silicon adhesive and mount into hole.
NOTE: When surface mounting magnet be sure there is enough clearance to prevent the magnet from becoming
damaged when closing the window or door.
10341400 rev A
www.GE-Interlogix.com 2266 Second Street North
North St. Paul, MN 55109
Phone: 651-777-2690
USA & Canada: 800-777-5484
Technical Service: 800-777-2624 12345 SW Leveton Drive
Tualatin, OR 97062
Phone: 503-692-4052
USA & Canada: 800-547-2556
Technical Service: 800-648-7424
Faxback: 800-483-2495
GE Interlogix
Made in Taiwan
C-UL-US Specifications
Part Loop Electrical Gap
Number Type Configuration Distance
R1075 Closed N/O
1
/
2
"
** European Union Specifications: 48 VAC/DC Max., 0.5 Amp
** FORM A (R1075)
Voltage: 100 VAC/DC Max
Current: 0.5 A Max
Power: 7.5 W Max
WARNING: Each electrical rating is an individual maximum and cannot be exceeded!
ULC Specifications
All Contacts: 30 VDC, 50 mA max Gap Specifications: *
Standard Gap
1.31"
33.3 mm
.44"
11.2 mm
.13"
3.3mm
.38"
9.5mm
hole diameter:
.13"
3.3mm
#4 Countersink
Magnet
Part No. 1830
(included)