Interlogix NX-1700E - Manual (Page 17)

NX-1700E Card Reader 17
IX. GLOSSARY
TERM DESCRIPTION
Alternative Mode Alternative mode is an optional scan method, as opposed to the default Legacy mode (see below).
The card is to be continuously held at the reader for a specified number of beeps. Example: Hold
the card at the card reader’s sensor for a total of 2 beeps. This is a “double beep” in the Alternative
mode. This method becomes available when Location 272, Segment 1, Option 6 is disabled.
Double
Beep………………. An audible indicator (beep, beep).
Double Beep Scan……….. When a user card is scanned and held at the reader for 2 beeps, the reader will perform the functions
as programmed in Location 241, Segment 4.
Legacy Mode……………… Legacy mode is used to describe the default operation of the card reader’s scanning method. This
mode uses the same scan methods as prior versions of the card reader modules. Example: Pass a
user card by the reader’s sensor, remove it from the field, then pass the card by the reader’s sensor
once again during the time programmed in Location 244, Segment 1. This is a “double scan” in the
legacy mode.
Request To Exit
(RTE)…… A zone can be programmed to monitor an open door. The RTE activates the onboard open collector
output and sends a message on the buss.
Scan………………………. To “present” or pass a card or FOB within sensing range of the card reader module.
Single Beep……………….. An audible indicator (beep).
Single Beep Scan………… When a user card is scanned and held at the reader for 1 beep, the reader will perform the functions
as programmed in Location 241, Segment 3.
Triple Beep………………... An audible indicator (beep, beep, beep).
Triple Beep Scan…………. When a user card is scanned and held at the reader for 3 beeps, the reader will perform the functions
as programmed in Location 241, Segment 5.
X. FCC INFORMATION
This device complies with Part 15 of the FCC rules. Operation is subject to the following three conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
3. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
FCC ID: CGGNX-1700E
XI. UNDERWRITERS LABORATORIES INFORMATION
The NX-1700E module has received UL listing:
UL294 Access Control Systems Units
XII. SPECIFICATIONS
DIMENSIONS Approx. 1.5"W x 4.5"L x 1"D with 6’ cable
OPERATING POWER 12 VDC, Supplied by NX-6, NX-8, NX-8E, or NX-320E
CURRENT DRAW 40mA Standby with Green LED
110mA Maximum
OPERATING TEMPERATURE -31 to +151 degrees F
5 to +66 degrees C
SHIPPING WEIGHT < 1 lb.
1420 N. MAIN STREET; GLADEWATER, TEXAS 75647
Main 800-727-2339 Technical Support 888-437-3287
Outside the US 903-845-6941 Sales & Literature 800-547-2556