V. programming, A. using the led keypad, Action – Interlogix NX-1700E User Manual
Page 4: Entering the program mode, Entering the module address, Programming a location, To enter a location, To change location data, To exit a location, To review the data
V.
PROGRAMMING
A. USING THE LED KEYPAD
NOTE: The NX-108E / NX-116E / NX-124E series keypads should not be used to program user cards.
ACTION
RESULT
E
NTERING THE
P
ROGRAM
M
ODE
Enters the Program Mode.
Stay, Chime, Exit, Bypass & Cancel LEDS will flash.
[
Go To Program Code
]
Factory Default is
If the "Go To Program Code" is valid, the "Service" LED will flash and
the 5 function LEDs will illuminate steady. You are now in the
Program Mode and ready to select the module address.
E
NTERING THE
M
ODULE
A
DDRESS
Scan a card.
The card reader will address itself.
#
(example only)
Enters the module address. Refer to Table IV-1 on page 3 for the
address assigned by the card reader module itself.
The Armed LED will illuminate while it is waiting for a programming
location to be entered.
P
ROGRAMMING A
L
OCATION
If an attempt is made to program an invalid entry for a particular segment, the keypad sounder will emit
a triple error beep (beep, beep, beep), and remain in that segment awaiting a valid entry.
To Enter a Location:
[location] #
The Armed LED will flash. If the location is valid, the "Armed" LED
will extinguish, the "Ready" LED will illuminate, and the zone LED’s
will show the data for the first segment of this location.
To Change Location Data:
[changed data]
The "Ready" LED will flash to indicate a data change in process and
will continue until the data is saved.
The new data is saved.
The keypad will increment and display the next segment’s data.
NOTE: Repeat these steps until the last segment is
reached.
To Exit a Location:
#
Exits from this location. The “Ready” LED will extinguish. The
"Armed" LED will illuminate waiting for a new programming location to
be entered.
To Review The Data:
[location] #
The Armed LED will flash. If the location is valid, the "Armed" LED
will extinguish, the "Ready" LED will illuminate, and the zone LED’s
will show the data for the first segment of this location.
(Do not enter data.)
The next segment is displayed. Each time
is pressed, the data of
the next segment will be displayed for review.
Shortcuts:
Previous location.
Same location.
Next sequential location.
4
NX-1700E Card Reader