Coway BA08-AR - Manual (Page 11)

11
For I
nf
orma
tion
PAR
TS NA
m
E / KEEP
iN
mi
ND
KEEP IN MIND
 Connect the power .
Turn on the product by connecting the power plug to the electrical outlet and
pressing the power selection button on the control panel.
The bidet works normally only when the electricity is connected.
 Open the main water supply valve .
The main water must be supplied to operate the bidet normally.
 Check whether the product is in power saving mode
before use .
- When you set the bidet body power saving mode, if there aren’t a seat
sensor sensing and a button operation for 30 minutes, a warm water/seat
temperature operates as ‘Low’ status and the power save mode is kept.
- In the power save mode, the power selection indicator is turned off.
- When you sit on the bidet seat or press the button on the control panel, a
power selection indicator is turned on and the water/seat temperature is operated as the last setting.
- If you sit on the bidet seat or the power selection indicator doesn’t be turned on even if you press the
button on the control panel, as the power is turned off, use after pressing the power selection button and
turning on the power.
Setting Special Mode
 Setting/canceling power saving mode
1) Turn on the remote control by pressing the power selection button on the remote control with pulling out
the power plug, and plug in the power plug with pressing the rear cleansing function selection button of
the bidet body (Alarm).
2) Press the rear cleansing function selection button on the remote control and select the desired status.
- The alarm rings 1 time (ding) : It means the release of the bidet body power save mode.
- The alarm rings 2 times (ding ding) : It means that the bidet body power saving mode was set.
3) When you select the wanted status and press the air dryer function selection button on the remote
control, the selected setting is saved and it is switched to the waiting status (The alarm rings three times
(ding ding ding)).
 Setting/canceling seat sensor lock mode
1) Turn on the remote control by pressing the power selection button on the remote control with pulling out
the power plug, and plug in the power plug with pressing the rear cleansing function selection button of
the bidet body (Alarm).
2) Press the front cleansing function selection button on the remote control and select the desired status.
- The alarm rings 1 time (ding) : It means the release of the seat sensor lock mode.
- The alarm rings 2 times (ding ding) : It means that the seat sensor lock mode was set.
3) When you select the wanted status and press the air dryer function selection button on the remote
control, the selected setting is saved and it is switched to the waiting status (The alarm rings three times
(ding ding ding)).
This product is for 120 V~, 60 Hz only.
Please connect the power plug to a dedicated grounded
electrical outlet for 120 V~, 60 Hz.
Tips
1021214 BA08-A 사용설명서_미주향_(09.06.10)_003.indd 11 2009.6.10 6:16:47 PM