Philips AJ3953 - Manual (Page 3)

tngiisti UUNI KUL:>/ IIV
51
ALLAI lUN
CONTROLS (See figure B and [ 2 ])
CD PLAYER
®STOPB
- stops CD playback;
- stops sleep function in CD mode;
- stops the active CD alarm for 24 hours.
©PLAY/PAUSE HI
- starts/ pauses CD playback.
©SEARCH r«, M-i
- skips CD tracks/ searches for a particular passage.
GENERAL
©SLEEP
- activates and adjusts the sleep time.
©REPEAT ALARM/ brightness control
- changes the brightness of the display illumination:
- switches off the alarm for a 9 minute period:
- stops sleep function in CD, buzzer or radio mode.
©WEEKENO-SLEEPER
- deactivates alarm 1 and/ or 2 for the weekend.
©Display
- shows the clock/ alarm time and status of the set.
©ALARM 1 MODE/ OFF or ALARM 2 MODE/ OFF
- sets/ reviews/ switches off alarm 1 or 2.
RADIO
©ON/ OFF
- switches the radio on/ off:
^ stops sleep function in radio mode:
- stops the active radio alarm for 24 hours.
©FM/AM
- selects the radio waveband.
SETTING TIMES
©ALARM 1. ALARM 2, TIME
- sets the respective alarm or clock time
- adjusts clock/ alarm times;
- adjusts the gentle wake minimum and maximum
volume level for alarm I or 2;
- selects a CD wake up track for alarm 1 or 2.
©VOLUME A
- adjusts the sound level.
©Dial lens
©SET DAY
- sets the day for weekend sleeper activation.
©24 HR RESET
- stops the active buzzer, radio or CD alarms for 24
hours.
©LIFT TO OPEN
- opens/ closes CD door.
©TUNING
' tunes to a radio station.
©Pigtail - antenna to improve FM reception.
©Power cord - for AC power supply.
The type plate is located on the bottom of the set.
This product complies with the FCC-Rules, Part 15 and
with 21 CFH 1040.10. Operation is subject to the
following two conditions:
1 This device may not cause harmful Interference, and
2 This device must accept any interference received,
including interference that may cause undesired
operation.
CAUTION
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
INSTALLATION
Power Supply and Demo mode
1 Check if the power voltage, shown on the type plate
on the bottom of the set. corresponds to your local
power supply. If it does not, consult your dealer or
service center.
2 Connect the power plug into the wall outlet. The
power supply is now switched on and the dispiay
will show the PHILIPS demo mode.
- PH../L./PSscrolls across the display continuously.
• Press any control (with the exception of
REPEAT ALARM/ brightness control on the set) to
exit the demo mode.
3 To disconnect the set completely from the power
supply, withdraw the power plug from the wall
outlet.
Standby power consumption (clock mode)..... 3 W