Philips AJ3953 - Manual (Page 4)

N
SETTING TIMES, DAY CD
MEMORY BACKUP
The memory backup conveniently allows your day, alarm
and clock time settings to be stored for up to 3 minutes
when there Is a power interruption e,g. AC power
failure.
The complete CD clock radio and illumination will be
switched off. As soon as the power supply returns, the
display will indicate the correct time,
• If power supply returns after 3 minutes, the display
will show the PHILIPS demo mode and you will
need to re-enter the day, alarm and clock times.
BASIC FEATURES
Illumination brightness
• Press REPEAT ALARM/ BRIGHTNES CONTROL Once Or
more.
— The brightness of the display will change In this
sequence:
LOW-* MEDIUM-* BRIGHT-* LOW...
Volume
Press VOLUME or A to adjust the volume level. The
volume level UO- is indicated as a number from 0-32.
SETTING THE CLOCK AND ALARM TIMES
The time is displayed using the 12 hour clock where the
PM indicator lights up (on = PM, off = AM).
7 Press TIME, ALARM 1 or ALARM 2 briefly until the
respective clock or alarm time display flashes.
2 Press and hold down i, ^to adjust both the hours
and minutes.
• By pressing 1 or J respectively, the time increases/
decreases rapidly and continuously from minutes to
hours. Release ^ or Jwhen you have reached the
correct setting.
• If you need to adjust the time slowly, minute by
minute, press 1 or J briefly and repeatedly.
3 Press TIME, ALARM 1 or ALARM 2 to confirm your
respective time setting.
SETTING THE DAY
Setting the day enables you to set the WEEKEND-
SLEEPER function. If you attempt to use the
WEEKEND-SLEEPER prior to setting the day (Monday
to Sunday, 1-7) dR'd will show briefly in the display to
remind you to set the day first.
7 Press SET DAY.
2 While the day display is shown, press SET DAY
again once or more to select the day numbered from
dAY 1-7 (Monday-Sunday):
The display will revert to show the clock time.
CD PLAYBACK
7 To open the CD door, lift at the edge marked
LIFT TO OPEN !
2 Insert a CD with the printed side facing up, and close
the door.
3 Press PLAY/ PAUSE Ml to start playback.
^ The CD indicator taiM , Cd: - - and the total
number of tracks are shown, followed by the first
track number before returning to clock time.
- door is shown if you have not closed the CD
door/ open the CD door during playback.
- naCd is shown if no CD has been inserted/
inserted incorrectly
- r,FCd is shown if the CD-R(W) is non-finalized
- or r indicates a general error in operation of the
set.
- The display returns to clock time.
4 Adjust the sound with VOLUMEor A.
5 To interrupt, press PLAY/ PAUSE Ml.
• The current track number shows briefly before
returning to clock time. Wi» flashes during pause.
6 Press PLAY/ PAUSE Ml again to resume playback.
7 Press STOP ■ to stop playback.
-* The display returns to clock time.